Extron Electronics DTP T USW 333 User Guide - Manual (Page 14)

DTP T USW 333 • Installation and Operation 9
Operation
Controls and Indications
HDCP
SIGNAL
AUTO
SWITCH
DTP T USW 333
CONFIG
1
STATUS
2 3
1 2 3
MODE NORMAL AUTO
2
7
3
1 4 5 6
Figure 8. Power Indicators
Auto Switch mode indicator
a
Auto Switch LED — When lit, indicates that the switcher is in auto-input switching
mode. When unlit, the switch is in normal (manual) mode (see Selecting the switch
mode on page 11).
Input selection controls and indicators
b
Input 1 through 3 buttons — Each Input button selects the associated input for
output (see Switching inputs on the next page).
The Input buttons are also used to toggle auto-input switching mode on and off (see
“Auto-input switching mode controls,” below).
c
Input 1 through 3 LEDs — The input LEDs identify the selected input.
Auto-input switching mode controls
The switcher supports auto-input switching mode. When auto-input switching mode is
enabled, the switcher continuously monitors all inputs and automatically switches to the
highest-numbered input with video sync pulses present. If video is absent from all inputs,
input 1 is selected.
d
Mode button — The Mode button is used with the Normal button or the Auto button
to select the switching mode (see Selecting the switch mode on page 11).
This button is a secondary function of the Input 1 button.
e
Normal button — The Normal button is used with the Mode button to select normal
mode (see Selecting the switch mode on page 11).
This button is a secondary function of the Input 2 button.
When you change from auto-input switching to normal (manual) mode, the last input
selected in auto-input switching mode remains selected until you manually select a
different input.
f
Auto(switch) button — The Auto button is used with the Mode button to select auto-
input switchinging mode (see Selecting the switch mode on page 11).
This button is a secondary function of the Input 3 button.