John Wood Takagi - 910 - Manual (Page 34)

34
Optional Items
1. Temperature Remote Controller: TM-RE30
The Temperature Remote Controller has two functions. It allows the output
temperature from the water heater to be adjusted within the range of 38°C to
85°C (100°F to 185°F), and it also works as a diagnostic tool that will give a
concise error code whenever there is a problem with the unit. The temperature
options are 38°C, 40.5°C, 43°C, 46°C, 49°C, 52°C, 55°C, 57°C, 60°C, 63°C,
65.5°C, 68°C, 71°C, 74°C, 77°C, 79°C, 82°C and 85°C (100°F, 105°F, 110°F,
115°F, 120°F, 125°F, 130°F, 135°F, 140°F, 145°F, 150°F, 155°F, 160°F, 165°F,
170°F, 175°F, 180°F and 185°F.) See the troubleshooting section for informa-
tion on possible error codes.
2. Multi system controller: TM-MC01
The Multi- system controller can control a maximum of 10 water heaters, from
15,000 BTU to 3,800,000 BTU. It also works as a diagnostic tool that will give
a concise error code whenever there is a problem with the unit. Usage of the
TM-MC01 requires having the TMRE30 remote controller.
3. Vent Damper: TM-BF50
The Vent Damper prevents the backflow of air through the exhaust vent. This
helps prevent harmful exhaust gases from entering the home, as well as help-
ing to prevent the unit from freezing in areas where cold air can be blown or
drawn into the exhaust system. Install this vent damper in accordance with the
manufacturer’s installation instructions, and any applicable codes.
4. Direct-Vent Kit: TM-DV50
This kit can be used convert the 910 from a conventional vent system to a
direct-vent (or sealed combustion) system. This is a CSA tested conversion
kit. Install this conversion kit in accordance with the manufacturer’s installation
instructions and any applicable codes.