John Wood SpaceSaver (2.5 Gallon) - Manual (Page 5)

5
Electrical Requirements
This water heater is equipped for one type voltage only.
Check the rating plate on the side of the water heater for
the correct voltage. DO NOT use this water heater with
any voltage other than the one shown on the rating plate.
Failure to use the correct voltage can cause problems
which can result in DEATH, SERIOUS BODILY INJURY,
OR PROPERTY DAMAGE. If you have any questions or
doubts consult your electric company.
If you lack the necessary skills required to properly install
the electrical wiring to this water heater, do not proceed but
have a qualifi ed electrician perform the installation.
When making the electrical connections, always make
sure:
•
The electrical supply has the proper overload fuse or
breaker protection.
• Wire sizes and connections comply with all applicable
codes.
• Wiring enclosed in approved conduit (if required by
local codes).
• The water heater and electrical supply are properly
grounded.
• The tank is completely filled with water before making
any electrical connections (see Figure 2).
• A circuit connects directly from the main fuse or circuit
breaker box, has its own fuse or circuit breaker and
terminates in a receptacle adjacent to the water heater.
• Do not use an extension cord set with this water heater.
• Do not operate this water heater if it has a damaged
plug.
Failure to do so can result in
death or electrical shock.
Replace all parts and panels
before operating.
Disconnect power before
servicing.
Electric Shock Hazard
WARNING
NOTE: Applying electrical power to elements that are not submerged
in water will destroy them. The manufacturer will not warranty any
elements damaged in this manner.
Figure 2
Heating Element
Figure 3
Wiring Diagram
BLACK BROWN
WHITE
GROUND
GREEN
BLUE
ELEMENT
THERMOSTAT
HIGH LIMIT TEMPERATURE
SENSOR
INDICATOR
LIGHT
GREEN/YELLOW
WHITE
WHITE