Xylem PHIX COMPACT pH and Redox Transmitter - Manual (Page 5)

5 SW 836502
Introduction
Introduction
Thank you for choosing a pHix ® Compact
pH / Redox transmitter.
We have done everything possible to make
a pH / Redox transmitter that can fulfill all
your demands.
pHix
® Compact is very simple to install and
connect, as electrode, fitting and transmitter
is built together in the same NEMA 6X class
enclosure. By doing so, all error sources
like e.g. bad cable connections and leaking
fittings are eliminated.
As pHix
® Compact is equipped with an uni-
on flange in one end and male thread in the
other, the transmitter is very easily mounted
in open tanks as well as pipes without the
usual use of fittings.
You can always contact your representative
or the MJK Service Hotline for advice and
guidance. Also, take a look at http\\:www.
phix.dk.
pHix
® is registered trademark of MJK.
Safety instructions
1: Read this manual carefully.
2: Be aware of the environment on the in-
stallation site. Wear necessary protective
equipment and follow all current safety
regulations.
3: pHix ® Compact can provide a start signal
for dangerous machinery. Always ensure
that connected machinery and other
equipment are effectively being put out
of service (i.e. removal of main fuses,
lock main- and/or security switches in
off position) before commencing setting,
fault finding, service and maintenance
work etc.
Repair
1: Repair must only made by MJK or by a
service representative approved by MJK.
Explosion hazardous areas
pHix ® Compact must not be installed in
explosion hazardous areas!