Xylem H-310 - Manual (Page 15)

H-310
Installation 2-5
Figure 2-2
Step 5- With a small screw driver, loosen the screw of the terminal strip to open each slot where
you want to insert a wire.
Step 6- Insert the wires.
Step 7- Tighten the screw down while holding the wire in place.
Step 8- Check to make sure each wire is connected securely in the correct slot.
Step 9- Tighten the gland nut so it grips your hook-up cable tightly.
Step 10- Replace the lid and screw the lid down on the junction box.
Step 11- Check your desiccant packs. Replace if necessary.