YSI DIQ/S 182-PR System 182 - Manual (Page 82)

The SETTINGS menu System 182
5 - 4 ba76024e01 02/2012
5.4 Relay output R1/R2/R3
In these menus you can link sensors with the relay outputs of the
Universal Transmitter and adjust the outputs. The various setting
options are described in detail in the chapter 6 R
ELAY OUTPUTS menu.
5.5 PROFIBUS config.
You can set the PROFIBUS address in this menu (proceeding, see
section 7.3). All information needed to connect the DIQ/S 182-PR to a
PROFIBUS plant is given in chapter 7 PROFIBUS
CONNECTION .
5.6 System
The settings in the SYSTEM menu comprise:
 Date/Time
 Pressure/Altitude
This setting is important if you want to carry out D. O. measurements
with the System 182.
(adjustable range: 500 ... 1100 mbar or 0 ... 5955 m altitude).
 Settings a
/
z?
Here you can configure the password for the settings.
For details on the passwords refer to section 4.6.
 Calibrate a
/
z?
Here you can configure the password for calibration.
For details on the passwords refer to section 4.6.
 Display contrast
Here you can set the display contrast for optimum readability.
 Delivery state
Here you can reset all settings to default. Only the date, time and
contrast setting for the display will remain stored. If the settings
password is active, a password prompt appears before the reset. In
any case a security prompt appears to prevent an inadvertent reset.