Xylem 8200 Series Base Mounted Centrifugal Fire Pumps AC2675 REV.C - Manual (Page 3)

DESCRIPTION
The 8200 Series Centrifugal Fire Pumps are
framed mounted pumps which feature – high
efficiency, rugged construction, compact design,
foot mounted volute and regreasable bearings.
These features, along with the horizontal split
case, make installation, operation and service
easy to perform.
OPERATIONAL LIMITS
Unless special provisions have been made for
your pump by AC Fire Pump Systems, the
operational limits for 8200 Series Centrifugal Fire
Pumps are as follows:
MAXIMUM WORKING PRESSURE
Listed on pump nameplate.
SEAL OPERATING LIMITS
PACKING
PH Limitations 7-9; Temperature Range 0 to
+200°F
For use on open or closed systems which require
a large amount of makeup water, as well as
systems which are subjected to widely varying
chemical conditions and solids buildup.
PUMP IDENTIFICATION
There are two identification plates on each pump.
The pump rating plate gives identification and
rating information. Figure 1 shows an example of a
typical Rating Plate.
Permanent records for this pump are referenced
by the Serial Number and it must, therefore, be
used with all correspondence to order all spare
parts and replacement parts. The fourth digit
indicates the specific pump on orders for more
than one pump. For example, if an order called for
six pumps, all pumps would have the same first
three sets of digits and the last digit will change to
identify each of the six. (e.g. 03-123456-01-01, 03-
123456-01-02, etc.)
The frame plate, shown below in Figure 2, gives
information concerning the bearings and their
lubrication. The inboard and outboard bearing
numbers refer to the bearing manufacturer’s
numbers.
FIGURE 1 – RATING PLATE
FIGURE 2 – FRAME PLATE
3