Acer Altos G701 - Manual (Page 51)

41
Installing and removing storage
devices
The system supports one 3.5-inch and three 5.25-inch internal storage
devices. The system comes pre-installed with a floppy drive and a
CD-ROM drive. The two empty 5.25-inch half-height bays allow you to
install additional drives such as another CD-ROM drive or a tape drive.
These would provide the system additional storage capacity.
Replacing the 3.5-inch floppy drive
1 Observe the ESD precautions and pre-installation procedures
described on page 31.
2 Disconnect the IDE and floppy drive cables from the old drive.
3 Press the release bracket on both sides of the drive carrier (1)
before pulling it out from the chassis (2).
AA G701 - EN.book Page 41 Monday, March 17, 2003 4:24 PM