Camp Chef PG24 - Manual (Page 4)

PROBE
1. Plug the Meat Probe into the Probe receptacle on the control panel. Run the probe and wire through the probe access
hole on the side of the grill. See Fig 11.
2. See instructions for Meat Probe.
BURNER CLEAN-OUT
Before each use the burner should be cleaned out by pulling the knob on the right side of the grill to open the burner
clean-out. This will allow the ash from previous use to fall into the cup under the grill. The cup should be removed and
emptied and then reinstalled before each use. After cleaning out the burner make sure to close the burner clean-out by
pushing the knob in on the right side of the grill.
Every couple of months you can remove the grill grates, grease tray, and heat deflector and clean the inside of the grill.
This is easiest to do using a vacuum.
FILLING THE AUGER TUBE
The first time you use your grill or any time the hopper has ran out of pellets you will need to fill the auger tube. This
simply means you must fill the auger tube with pellets until pellets reach the burner. This is done by turning the dial to
the FEED position. This will turn the auger on and the digital readout will display “FEED”. The auger will remain on for no
more than 7 minutes. This is ample time for the pellets to reach the burner. It is easiest to open the burner clean-out by
pulling the knob on the right side of the grill. Once you hear pellets dropping into the cup you can close the clean-out port
by pushing the knob on the right side of the grill and then select your cooking temperature. Always make sure the burner
clean-out port is closed by pushing in the knob on the right side of the grill before selecting any of the cook settings.
INSTRUCTIONS
CONTROLLER EXPLANATION
POWER SWITCH
Used to turn the main power onto the pellet grill. If the dial is on Shutdown when the power switch is turned on the
digital readout will display “-----“. The dial must be rotated to any of the other positions before the grill will start. If the
power is turned on with the dial in any other position than Shutdown the grill will immediately start that function.
“O” is Off. “-“ is On. See Fig. 12
PROBE
PROBE HOLE
CLEANOUT PORT KNOB
CLEANOUT PORT KNOB
HEAT DEFLECTOR AND DRIP TRAY
1. Install the Heat Deflector and Drip tray as shown in Fig 6 and Fig 7.
WARMING RACK AND COOKING GRATE
1. Install the Warming Rack and Cooking Grate as shown in Fig 8.
CLEAN-OUT PORT KNOB
1. Clean-out Port Knob must be pushed in when cooking. See Fig 9.
2. Pull Clean-out Port Knob out to empty ash into ash cup. See Fig 10.
3. See instructions for burner clean-out.
HEAT DEFLECTOR
DRIP TRAY
WARMING RACK
COOKING GRATE
HEAT DEFLECTOR
DRIP TRAY
Fig. 6 Fig. 7
Fig. 8
Fig. 9 Fig. 10
Fig. 11
Fig. 12