Camp Chef TB90LWG - Manual (Page 3)

NOT attempt to move the
appliance or the cooking vessel.
18. Avoid bumping or or impact with
the appliance to prevent spillage
or splashing of hot cooking liquid.
19. Do NOT move the appliance
when in use. Allow unit to cool
to 115°F (45°C) before moving
or storing.
20. This appliance will be hot
during and after use. Use
insulated oven mitts or gloves
for protection from hot surfaces
or splatter from cooking liquids.
21. In case there is a fire, call the
local fire department or dial
911. Stay clear from flames.
Do not attempt to extinguish an
oil or grease fire with water.
22. Use only accessories, such as
cooking vessels recommended
by the manufacturer, to allow
safe and proper performance
of the product. Never use
a cooking vessel larger than
the capacity and diameter
recommended by the
manufacturer.
23. This product is not intended for
commercial use.
24. Always allow the appliance to
cool before covering with patio
cover.
25. Always cover the appliance,
with patio cover (if supplied),
when not in use.
26. In the event the appliance has
been exposed to water, tilt the
appliance forward and allow
water to drain from the burners
before attempting to ignite.
WARNING
Combustion by-products produced
when using this product contain
chemicals known to the State of
California to cause cancer, birth
defects, or other reproductive
harm.
• NEVER store a spare LP tank
under or near appliance or in
enclosed areas. NEVER fill the
cylinder beyond 80% full. An
overfilled spare LP
tank is
hazardous due to possible gas
released from the safety relief
valve. Failure to follow these
instructions exactly could cause a
fire resulting in death or serious
injury.
• If you see, smell, or hear escaping
gas, immediately get away from
the LP tank/appliance and call your
fire department.
• All spare LP tanks must have safety
caps installed on the LP tank outlet.
LP Tank Removal, Transport
and Storage
• Turn OFF all control knobs and LP
tank valve. Turn coupling nut
counterclockwise by hand only –
do not use tools to disconnect.
Install safety cap onto LP tank
valve. Always use cap and strap
supplied with valve. Failure to use
safety cap as directed may result in
serious personal injury and/or
property damage.
• A disconnected LP tank in storage
or being transported must have a
• Never operate appliance with LP
tanks out of correct position
specified in Assembly Instructions.
• Always close LP tank valve and
remove coupling nut before
moving LP tank form specified
operating position.
Warning: Hose is a trip hazard
24"
Installation Safety Precautions
• Use appliance only with LP
(propane) gas and the
regulator/valve assembly supplied.
• Installation must conform with
local codes, or in their absence with
National Fuel Gas Code, NFPA
54/ANSI Z223.1. Handling and
storage of LP cylinders must
conform to LP
Gas Code
NFPA/ANSI 58. Appliance is not
for use in or on recreational vehicle
and/or boats.
• Do not modify this appliance.
Modifications will result in a safety
hazard. Questions regarding
certification in other areas may be
addressed to 1-435-752-3922.
• Apartment Dwellers: Check with
management to learn the
requirements and fire codes for
using an LP Gas appliance at an
apartment. If allowed, use outside
on the ground floor with a 10 foot
clearance from walls or rails. Do
NOT
use appliance on
or under any apartment,
condominum balcony or deck.
• Before opening LP tank valve,
check the coupling nut for
tightness. When appliance is not in
use, turn off control knob and LP
tank valve on supply cylinder.
• Never use LP tank if visibly rusted,
damaged, or out of date.
• If you notice grease or other hot
material dripping from appliance
onto valve, hose or regulator, turn
off gas supply at once. Determine
the cause, correct, clean and
inspect valve, hose and regulator
before continuing. Perform a leak
test.
• The regulator may make a
humming or whistling noise during
operation. This will not affect the
safety or use of appliance.
• Clean and inspect the hose before
each use of the appliance. If there is
evidence of abrasion, wear, cuts or
leaks, the hose must be replaced
prior to the appliance being put into
operation. See product sheet for
hose & regulator information.
• Do not block holes in bottom or
sides of appliance.