AVSL Citronic CX34 - Manual (Page 6)

6 170.929UK, 170.932UK User Manual
Specifications
Model CX23 CX34
Power supply 115/230Vac selectable 50/60Hz (IEC)
Input impedance: balanced 40kΩ 50kΩ
Input impedance: unbalanced 20kΩ 25kΩ
Output impedance 220Ω 200Ω
Crossover ranges: stereo 50Hz-5kHz;750Hz-7.5kHz
45-960Hz (switchable 10x) or
450Hz-9.6kHz
Crossover ranges: mono
50Hz-5kHz;750Hz-7.5kHz;
2kHz-20kHz 45-960Hz (switchable 10x) or
450Hz-9.6kHz
Filter slope 18dB/octave 24dB/octave
Frequency response 20Hz-25kHz +0/-1dB 20Hz TO 20KHz, +0/-0.5dB
Signal to noise ratio >90dB
THD <0.006% @ +4dBu, 1KHz <0.004% @ +4dBu, 1KHz
Dimensions 482 x 170 x 44 mm
Weight 2.5Kg
Troubleshooting
No function and Power
switch LED is not lit Ensure mains voltage is correct (check selector) and connected properly
Ensure front panel power switch and mains outlet switch are on
Power is on but no
audio output
Check XLR leads are OK and connected properly
Check that INPUT and OUT GAIN controls are not turned fully down
Check that inputs and outputs are connected the correct way around
Check that LOW out is not connected to amp for mid-high cabs in error
Check that MID or HIGH out is not connected to amp for subs in error
Distorted output
Reduce INPUT and HIGH/MID/LOW OUT Gain controls
Lower XOVER FREQ for sub cabinets
Check frequency multiplier switches are set correctly
Output is very low
level
Check XOVER FREQ is set correctly for each output
Test phase switches of different outputs to hear if need to be inverted
Increase Gain control(s) to compensate
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.