AVSL Citronic MU16 - Manual (Page 2)

MU16 / MU26 User Manual
Introduction
Thank you for choosing the Citronic 16 channel UHF-series wireless system. This professional wireless set
provides a high quality microphone with a tuneable PLL UHF radio system for ultimate wireless quality and
versatility. Please read this manual before using this equipment in order to avoid damage through incorrect
operation and to get the best performance from your purchase.
Contents
Please take care when unpacking. Inspect for any damage and ensure you have the following components…

UHF wireless receiver

Mains power adapter

6.3mm mono jack lead

2 x 1.5V AA battery (4 pieces for MU26H and MU26N)

Rack-mounting adapters

Microphone / transmitter(s) – see table below
Model Stock code Microphone 1 Microphone 2
MU16H 171.829 Handheld transmitter -
MU26H 171.832 Handheld transmitter Handheld transmitter
MU16N 171.830 Discreet neckband mic. + bodypack -
MU26N 171.833 Discreet neckband mic. + bodypack Neckband mic. + bodypack
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by
qualified personnel before further use.
Avoid impact or heavy vibration to any components, dropping the microphone can cause capsule failure.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.
Safety
 Ensure that the correct adapter is used and that the mains voltage is as stated on the adapter.
 Avoid ingress of water or particles into the transmitter(s) or receiver
 Use alkaline or NiMH batteries in the transmitter(s) and remove if unused for long periods.
 Observe the correct polarity when replacing batteries
Placement
 Keep all components out of direct sunlight and away from heat sources.
 Do not place heavy objects on top of the receiver or transmitter(s)
 If rack-mounting receivers in pairs, use the supplied rack ears and coupling brackets.
 Keep the transmitter(s) and receiver away from damp or dusty environments.
Cleaning
 Use a soft cloth with a neutral detergent to clean the body of the microphone/transmitter and receiver.
 Lightly damp sterile wipes may be used on the microphone grille for hygiene purposes
 To avoid damage, do not use solvents to clean the components