beautypg.com

AVSL 178.856 QX15PA User Manual

Page 3

background image

QXPA User Manual

Controls

Powering up


Your new QXPA portable PA unit may arrive with you with the internal battery charged. Before

connecting to the mains, switch the unit on and see if the power LED lights. If not, you will
need to charge the battery before using away from a mains supply.

When not in use but connected to the mains, if the POWER switch is in the OFF position, the
internal battery will be re-charged from the mains supply. This can be observed by the

CHARGE LED which lights when charging. Connect the QXPA portable PA unit to the mains
using the appropriate mains IEC lead supplied. You may otherwise opt to connect the DC input

at the rear to an external 12Vdc supply (e.g car battery) or use the internal battery if charged.

Turn the VOLUME controls down (anti-clockwise) and turn the POWER switch on (the power
LED should light). BASS and TREBLE controls should remain pointing vertically (12-o-clock

position). Turn up the VOLUME control part way and switch VCV (voice controlled volume) off.
Your QXPA unit should now be ready to operate.

1.

USB port

2.

SD card slot

3.

Bass EQ control

4.

Master volume

5.

VCV switch

6.

Mic inputs (jack)

7.

Antenna sockets

8.

Wired mics volume

9.

VHF mics volume

10.

Bluetooth volume

11.

Bluetooth control

12.

Power LED

13.

Charge LED

14.

USB/SD/FM player

15.

Transport controls

16.

Treble EQ control

17.

Delay time control

18.

Echo level control

19.

Mix output (RCA)

20.

Line input (RCA)

21.

Line in (3.5mm)

22.

Mic contour control

23.

VHF RF indicators

24.

DC power fuse

25.

DC power input

26.

Power switch

27.

Mains inlet & fuse

This manual is related to the following products: