AVSL 170.145 BC4A - Manual (Page 3)

170.145, 170.146 User Manual
Setting up
For near-field or desktop use, space speakers apart for adequate stereo separation depending on
proximity to the listener. For installations using the supplied wall-mount brackets, attach the brackets
to a solid surface using fixings which are sufficient to hold the weight of the active speaker. Take
care to mount the active unit close enough to a mains outlet for the supplied adaptor to reach.
Fix the speaker units to the brackets at top and bottom using the supplied screw caps. Each can be
rotated to aim the general direction of sound output.
If the speakers are mounted at height or where falling objects may be hazardous, it is advised to
attach a secondary means of support (e.g. drop-wire or chain)
Operation
Connect the bare ends of the supplied speaker wire to the spring terminals on the satellite unit.
Note: WHITE wire to RED terminal, BLACK wire to BLACK terminal
The other end of the speaker wire carries a modular connector which is to be plugged into the active
unit (will only plug in one way round)
With the rotary control set to “Off”, connect the supplied 18Vdc adaptor to the d.c. input jack on the
rear of the active unit and plug into a suitable mains outlet. Connect the source signal into the active
unit via either L+R RCA connectors or 3.5mm stereo jack input.
Gradually turn the rotary control clockwise to switch on the amplifier (Power LED will light) and
increase volume level to the required amount.
To switch off, turn the rotary control all the way down until it clicks and the Power LED goes out.
Specifications
Power supply 18Vdc 1.0A adaptor (supplied)
Woofer 100mmØ (4“) reinforced paper cone
Tweeter 25mm balanced dome
Power rms 2 x 8W
Controls Combined On/Off + volume rotary
Input connections 3.5mm stereo and L+R RCA
Frequency response 120Hz - 20kHz
Dispersion 150° (-3dB)
Dimensions (each) 155 x 220 x 148mm
Weight (per set) 2.79kg