AVSL 154.091 DM-X10 - Manual (Page 7)

7 154.091UK User Manual
3.3 Programming
A program (bank) is a sequence of different scenes (or steps) that will be called up one after another.
In the DM-X10, 30 programs can be created with 8 scenes in each.
3.3.1 Entering Program Mode
Press the Program button until the LED blinks.
3.3.2 Create a Scene
A scene is a static lighting state. Scenes are stored in banks. There are 30 bank memories on the controller
and each bank can hold 8 scene memories. The DM-X10 can save 240 scenes total.
Action
1. Press and hold the PROGRAM button until the LED blinks.
2. Position SPEED and FADE TIME sliders all the way down.
3. Select FIXTURE(S) to begin adjusting the DMX values
4. Move faders to adjust parameters to the required setting for the fixture(s)
5. De-select a fixture to hold its DMX values
6. Adjust for all fixtures until all are set at the required state
7. Press the MIDI/ADD button
8. Select a BANK and then select a SCENE to store the scene
9. Press PROGRAM to store
10. Repeat the above process for up to 8 scenes in the bank
11. Hold the PROGRAM button to exit Program mode
Notes:
Deselect BLACKOUT if LED is lit.
Toggle the PAGE SELECT button to access channels 9-16
All LEDs flash to confirm storing a scene
Shortcut: Press [PROGRAM] [FIXTURES ] Adjust [Faders] [BANK] [SCENE] Press [PROGRAM] to store.
3.3.3 Running a Program
Action:
1. Use BANK UP/DOWN buttons to change Program banks if necessary
2. Press the AUTO DEL button repeatedly until the AUTO LED turns on
3. Adjust the program speed via the SPEED fader and the loop rate via the FADE TIME fader.
4. Alternatively you can tap the TAP DISPLAY button twice.
The time between two taps sets the time between SCENES (up to 10 minutes)
Note: Deselect Blackout if LED is lit.
3.3.4 Check Program
Action:
1. Press and hold the PROGRAM button until the LED blinks
2. Use BANK UP/DOWN buttons to change Program bank to review
3. Press the SCENES buttons to review each scene individually