Asus P4B-LX - Manual (Page 37)

ASUS P4B-LX motherboard user guide 2-17
2.8 Connectors
This section describes and illustrates the internal connectors on the
motherboard.
Do not place jumper caps over connector pins. Doing so may damage
your motherboard.
Always connect ribbon cables with the red stripe to Pin 1 on the
connectors. Pin 1 is usually on the side closest to the power connector
on hard drives and CD-ROM drives, but may be on the opposite side
on floppy disk drives.
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when
using ribbon cables with pin 5 plug).
Figure 2-21 Floppy Disk Drive Connector
P4B-LX
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4B-LX Floppy Disk Drive Connector
PIN 1
FLOPPY