Asus P5Q WS - Manual (Page 163)

ASUS P5Q WS 4-49
4.4.4 Marvell ® RAID configurations
The Marvell ® 6121 Serial ATA controller allows you to configure RAID 0 and RAID 1
sets on the Serial ATA hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two Serial ATA hard disk drives to the eSATA connectors on the rear
panel.
2. Boot up your computer, and press during POST to enter the BIOS
setup.
3. In the Advanced Menu, go to Onboard Devices Configuration, and set
Marvell IDE/eSATA to [RAID Mode].
3. Press to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Devices Configuration
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
SPDIF OUT Mode Setting [SPDIF]
Realtek Gigabit LAN [Enabled]
LAN Boot ROM [Disabled]
Realtek Gigabit LAN2 [Enabled]
Agere Firewire 1394 [Enabled]
Marvell IDE/eSATA [RAID Mode]
IDE/eSATA Boot ROM [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller
BIOS SETUP UTILITY
Advanced