Asus P5P41D - Manual (Page 49)

ASUS P5P41D 2-11
NB Over Voltage [Auto]
Manually set Northbridge Chipset Voltage or set to Auto for safe mode. Press <+> / <-> to
adjust the value. Configuration options: [Auto] [1.125V] [1.175V] [1.225V] [1.275V]
SB 1.5V Voltage [1.5V]
Manually set Southbridge Chipset Voltage. Configuration options: [1.5V] [1.6V]
CPU VTT [1.2V]
Manually set the FSB Termination Voltage. Configuration options: [1.2V] [1.3V]
CPU Over Voltage [Auto]
Allows you to adjust the CPU over voltage. Configuration options: [Auto] [+50mV] [+100mV]
[+150mV]
Setting a very high voltage may damage the component permanently, and setting a very
low voltage may cause the system to become unstable.
2.4.2 CPU Configuration
The items in this menu show the CPU-related information that the BIOS automatically
detects.
Ratio CMOS Setting [Auto]
Sets the ratio between CPU core clock and the FSB frequency. Press <+> / <-> to adjust the
value.
If an invalid ratio is set in CMOS, then the actual and set values may differ.
C1E Support [Enabled]
Allows you to enable or disable C1E Support. Configuration options: [Disabled] [Enabled]
Max CPUID Value Limit [Disabled]
Setting this item to [Enabled] allows legacy operating systems to boot even without support
for CPUs with extended CPUID functions. Configuration options: [Disabled] [Enabled]
Intel ® Virtualization Tech [Enabled]
Enables or disables Intel ® Virtualization Technology. Virtualization enhanced by Intel ®
Virtualization Technology allows a platform to run multiple operating systems and applications
in independent partitons. With virtualization, one computer system can function as multiple
virtual systems. Configuration options: [Enabled] [Disabled]
CPU TM function [Enabled]
Enables or disables Intel ® CPU Thermal Monitor (TM) function, a CPU overheating
protection function. When enabled, the CPU core frequency and voltage are reduced when
the CPU overheats. Configuration options: [Disabled] [Enabled]
Auto PSI [Enabled]
Allows you to eanable or disable the Auto PSI mode.
Configuration options: [Disabled] [Enabled]