Asus RS700-E7/RS8 - Manual (Page 38)

Chapter 2: Hardware setup 2-20
2.6 Cable connections
Pre-connected system cables
1. 8-pin BPPWR1 power connector (from backplane to motherboard)
2. System fan connectors (from motherboard FAN1-8 to system fans)
3. Auxiliary panel connector (from motherboard to front I/O board)
4. Panel connector (from motherboard to front I/O board)
5. USB connector (from motherboard to front I/O board)
6. SATA5 connector (from motherboard to SATAII/SAS backplane board to
connect ODD)
7. PSAS1/2 connectors (from motherboard to SATAII/SAS backplane board,
when using PIKE RAID card)
• The bundled system cables are pre-connected before shipment. You do
not need to disconnect these cables unless you will remove pre-installed
components to install additional devices.
• Refer to Chapter 4 for detailed information on the connectors.
1 2
3
5
2
2
2
2
2
2
2
6
7
4