Asus X900-PI - Manual (Page 31)

ASUS P3C-E User’s Manual 31
3. HARDWARE SETUP
CPU
3. H/W SETUP
1. Simply peel off the tab from the sensor and then stick the sensor near the middle
edge of the Intel boxed processor heatsink with fan (middle) or to either the
upper or lower edge of the Celeron™ heatsink (right), as indicated.
To Use the ASUS P2T-Cable
NOTE: The following procedures assume that you have properly attached a
heatsink onto an SECC/SECC2/SEPP.
ASUS P2T-Cable
The optional ASUS P2T-Cable can be
used for a Pentium
® III / II processor
packaged in an SECC/SECC2 or a
Celeron™ processor packaged in an
SEPP .
NOTE: The ASUS P2T-Cable can only be used in a Slot 1 motherboard with a
2-pin thermal sensor connector.
Sensor Connector Plug
Sensor
WARNING! Do not insert the sensor between the processor and heatsink, other-
wise, it will cause damage to the P2T-Cable.
IMPORTANT! ASUS guarantees accurate readings only for the ASUS Smart
Fan and the Intel boxed processor heatsink with fan because both have similar
heat distribution and heatsink material.
Tab
Sensor
←
OR STICK ABOUT HERE