Crc flood enable [disabled, Ht frequency [800 mhz, Ht data width (upstream) [16 bit – Asus K8V User Manual
Page 51: Ht data width (downstream) [16 bit, Asus k8v motherboard 2-15, Memclock mode [ auto
ASUS K8V motherboard
2-15
CRC Flood Enable [Disabled]
Enables or disables the CRC Flood that enable the generation of syncronized
packets on CRC Error. Configuration options: [Disabled] [Enabled]
HT Frequency [800 MHz]
Allows frequency selection of HyperTransport transfer from K8 CPU to AGP.
Configuration options: [200 MHz] [400 Mhz] [600 Mhz] [800 Mhz]
HT DATA Width (Upstream) [16 BIT]
Allows selection of HyperTransport upstream data width.
Configuration options: [16 BIT] [8 BIT]
HT DATA Width (Downstream) [16 BIT]
Allows selection of HyperTransport downstream data width.
Configuration options: [16 BIT] [8 BIT]
Memory Configuration
Memory Configuration
The Memory configuration menu item allows you to change the memory settings.
Select an item then press
Memory Configuration
Memory Configuration
ECC Configuration
Memory Configuration
MEMCLK can be set
by the code using
Memclock Mode
[Auto]
AUTO, or if you use
Bank Interleaving
[Auto]
LIMIT, you can set
CAS Latency (CL)
[Auto]
one of the standard
TRC
[Auto]
values.
TRFC
[Auto]
TRCD
[Auto]
TWR
[Auto]
TRWT
[Auto]
TRAS
[Auto]
TRP
[Auto]
DDR Clock Delay
[Auto]
2T Command
[Auto]
Memclock Mode [ Auto]
Allows you to set the memory clock mode. Set by the code using [Auto] or
select [Manual] to set using one of the standard values.
Configuration options: [Auto] [Limit]