Asus T2-P - Manual (Page 39)

39 ASUS Terminator 2 barebone system
2.10 Re-installing the power supply unit
After installing the system components and reconnecting the cables, re-
install the power supply unit (PSU).
To reinstall the PSU:
1. Connect the 4-pin 12V power
plug to the ATX12V connector on
the motherboard labeled
ATX12V. See page 81 for the
location of the ATX12V
connector.
2. Position the PSU over the
chassis.
3. Align the PSU side hook with the
metal slot located in the side of
the optical drive bay.
4. Slide the PSU toward the
direction of the rear panel until it
fits in place.
2
3
4
5. Secure the PSU with the screw
you removed earlier.
5
4
Make sure the PSU cables
do not interfere with CPU
and chassis fans.