Asus WL-320gE - Manual (Page 33)

3. Software
ASUS 802.11g Access Point 33
Chapter 3 - Software Configuration
Access Point
You can setup your wireless environment as shown in this figure:
Remote Bridge List
MAC Address
Enter the MAC address of the target ASUS 802.11g AP in order to designate
which ASUS 802.11g AP will be the partner for this ASUS 802.11g AP.
Note: The content in braces “( )” is the MAC address in the Remote
Bridge List of the AP. For example, WB1 have the MAC address of
WB in its Remote Bridge List.
In this case, there are six ASUS 802.11g APs and they are linked as wireless
bridges. Take one of them, named WB, as an example. WB is not in “AP
Only” mode and “Connect to APs in Remote Bridge List” is set as “Yes”, so
it can connect to WB3. Meanwhile, “allow anonymous” is set as “Yes” or
“Allow anonymous” is set as “No” but it has the MAC addresses of WB1,
WB2, and WB4 in the “Remote Bridge List”, so it can be connected by
WB1, WB2, and WB4.