Asus P8H77-M - Manual (Page 42)

1-30 Chapter 1: Product introduction
2. Intel ® H77 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1~2 [gray])
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10
configuration with the Intel ® Rapid Storage Technology through the onboard Intel ® H77
chipset.
• These connectors are set to [AHCI] by default. If you intend to create a Serial ATA RAID
set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].
Refer to section 3.5.3 SATA Configuration for details.
• Before creating a RAID set, refer to section 4.4 RAID configurations or the manual
bundled in the motherboard support DVD.
• When using NCQ, set the SATA Mode Selection in the BIOS to [AHCI]. Refer to section
3.5.3 SATA Configuration for details.
• You must install Windows ® XP Service Pack 3 or later versions before using Serial
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows ® XP SP3 or later versions.
SATA6G_2
G
N
D
R
S
A
TA
_T
X
P
2
R
S
A
TA
_TX
N
2
G
N
D
R
S
A
TA
_R
X
N
2
R
S
A
TA
_R
X
P
2
G
N
D
SATA6G_1
G
N
D
R
S
A
TA
_T
X
P
1
R
S
A
TA
_TX
N
1
G
N
D
R
S
A
TA
_R
X
N
1
R
S
A
TA
_R
X
P
1
G
N
D
P8H77-M
P8H77-M Intel ® SATA 6.0Gb/s connectors