Asus C8HM70-I/HDMI - Manual (Page 47)

ASUS C8HM70-I 2-23
USB Support [Partial In...]
[Disabled] All the USB devices will be available only after entering the
operating system (OS).
[Full Initialization] All the USB devices will be available during POST and in OS.
[Partial Initialization] Only the USB ports with keyboard and mouse can be detected
before entering OS.
PS2 Keyboard and Mouse Support [Auto]
[Auto] The PS/2 devices are available when the system boots up as long as these
devices are not reconnected or changed.
[Full Initialization] The PS2 devices are always available during POST.
[Disabled]
All the PS/2 devices will be available only after entering the operating All the PS/2 devices will be available only after entering the operating
system (OS).
Network Stack Driver Support [Disabled]
[Disabled] Disables network stack driver support during POST.
[Enabled] Enables network stack driver support during POST.
Next boot after AC Power Loss [Normal Boot]
[Normal Boot] Returns to normal boot up process after AC Power Loss.
[Fast Boot]
Accelerates the boot up speed after AC Power Loss.
2.7.2 Full Screen Logo [Enabled]
[Enabled] Enables the full screen logo display feature.
[Disabled] Disables the full screen logo display feature.
Set this item to [Enabled] to use the ASUS MyLogo 2™ feature.
Post Report [5 sec]
This item appears only when the Full Screen Logo item is set to [Disabled] and allows you to
set the waiting time for the system to display the post report. Configuration options: [1 sec] [2
sec] [3 sec] [4 sec] [5 sec] [6 sec] [7 sec] [8 sec] [9 sec] [10 sec] [Until Press ESC]
Post Delay Time [3 sec]
This item appears only when the Full Screen Logo item is set to [Enabled] and allows you to
set the Post Delay Time. Configuration options: [0 sec] [1 sec] ~ [10 sec].
2.7.3 Bootup NumLock State [On]
[On] Sets the power-on state of the NumLock to [On].
[Off] Sets the power-on state of the NumLock to [Off].
2.7.4 Wait for ‘F1’ If Error [Enabled]
When this item is set to [Enabled], the system waits for the F1 key to be pressed when error
occurs. Configuration options: [Disabled] [Enabled]