Asus M2N-VM DVI - Manual (Page 47)

ASUS M2N-CM DVI 1-35
14. System panel connector (10-1 pin PANEL)
This connector supports several chassis-mounted functions.
M2N-CM DVI
R
M2N-CM DVI System Panel Connector
F_PANEL
PLED
-
PW
R
PLED
+
Ground
GN
D
Reset
IDELED
+
IDELED
-
+HDLED RESET
PLED PWR BTN
• System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the chassis
power LED cable to this connector. The system power LED lights up when
you turn on the system power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin +HDLED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The IDE LED lights up or flashes when data is
read from or written to the HDD.
• AXT Power/Soft-off button (2-pin PWRBTN)
This connector is for the system power button. Pressing the power button
turns the system ON or puts the system in SLEEP or SOFT-OFF mode
depending on the BIOS settings. Pressing the power switch for more than
four seconds while the system is ON turns the system OFF.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system
reboot without turning off the system power.