Asus P5K SE - Manual (Page 47)

ASUS P5K SE 2-23
P5K SE
®
3 2 2 1
P5K SE Keyboard power
+5V
(Default)
+5VSB
PS2_USBPW
• The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise,
the system would not power up.
• The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
2. Keyboard power (3-pin PS2_USBPW)
This jumper allows you to enable or disable the keyboard and USB port 5-6
wake-up feature. When you set this jumper to pins 2-3 (+5VSB), you can
wake up the computer by pressing a key on the keyboard (the default is
the Space Bar) or using a USB device. This feature requires an ATX power
supply that can supply at least 1A on the +5VSB lead, and a corresponding
setting in the BIOS. The USBPWR5-6 jumper is for the internal USB
connectors that you can connect to additional USB ports.
P5K SE
®
3 2 2 1
P5K SE USB device wake up
USBPW1-4
USBPW78
+5V
(Default)
+5VSB
+5V
(Default)
+5VSB
USBPW9-12
2
1
2
1
3. USB device wake-up (3-pin USBPW1-4, USBPW5-8, USB9-12)
Set these jumpers to +5V to wake up the computer from S1 sleep mode
(CPU stopped, DRAM refreshed, system running in low power mode) using
the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep
modes (no power to CPU, DRAM in slow refresh, power supply in reduced
power mode).
The USBPWR1-4 and USBPWR78 jumpers are for the rear USB ports.
The USBPWR9-12 jumper is for the internal USB connectors that you can
connect to additional USB ports.