Saving the settings and exiting setup, Rebuilding a mirror drive – Asus P5K3 Deluxe User Manual

Page 150

5-42

Chapter 5: Software support

Saving the settings and exiting setup

When you have finished, highlight Save & Exit Setup using the up/down arrow key

then press to save the current RAID configuration and exit the JMB363

RAID BOS utility.
A dialogue box appears to confirm the action. Press to confirm; otherwise,

press to return to the JMB RAID BIOS menu.

To rebuild a Mirror drive:
1. In the main JMB363 RAID BIOS menu, highlight Rebuild Mirror Drive using

the up/down arrow key then press .

[Main Menu]

Create RAID Disk Drive

Delete RAID Disk Drive

Revert HDD to Non-RAID

Solve Mirror Conflict

Rebuild Mirror Drive

Save and Exit Setup

Exit Without Saving

Rebuilding a Mirror Drive

When one of the disks in a RAID 1 (Mirror) configuration is unplugged from the

system, then plugged in again, a dialogue box appears to ask you to rebuild the

Mirror drive. Press to confirm; otherwise, press .
This option allows you to rebuild the Mirror drive later and synchronize the data

between two hard disks.

2. Using the , move to the RAID Disk Drive List menu and highlight the

RAID set that you want to rebuild. Press ~~to begin rebuilding the Mirror~~

configuration.

A status bar at the bottom of the screen shows the progress of the rebuilding.

JMicron Technology Corp. PCI-to-SATA II/IDE RAID Controller BIOS v0.97

[Hard Disk Drive List]

Model Name

Capacity

Type/Status

HDD0: HDS722516VLSA80 164 GB

RAID Inside

HDD1: HDS722516DLA380 164 GB

RAID Inside

[RAID Disk Drive List]

Model Name

RAID Level

Capacity

Status

Members(HDDx)

RDD0: JRAID

1-Mirror

XXX GB

Rebuild

[Main Menu]
Create RAID Disk Drive