Asus P5QLD PRO - Manual (Page 47)

ASUS P5QLD PRO 2-25
2.7.2 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
P5QLD PRO Floppy Disk Drive Connector
PIN1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
FLOPPY
P5QLD PRO
2. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF)
port(s). Connect the S/PDIF Out module cable to this connector, then install
the module to a slot opening at the back of the system chassis.
The S/PDIF module is purchased separately.
P5QLD PRO Digital Audio Connector
+5
V
SPDIFOU
T
GN
D
SPDIF_OUT
P5QLD PRO