Asus P6X58D-E - Manual (Page 82)

3-24 Chapter 3: BIOS setup
Chapter 3
3.6.4 USB Configuration
The items in this menu allow you to change the USB-related features. Select an item and
press �Enter�� to display the configuration options.
The USB Devices Enabled item shows the auto-detected values. If no USB device is
detected, the item shows None.
USB Functions [Enabled]
[Enabled] Enables the USB Host Controllers.
[Disabled] Disables the controllers.
The following two items appear only when you set USB Functions to [Enabled].
NEC USB 3.0 Controller [Enabled]
[Enabled] Enables the USB 3.0 controller.
[Disabled] Disables the controller.
USB 2.0 Controller [Enabled]
[Enabled] Enables the USB 2.0 controller.
[Disabled] Disables the controller.
USB Configuration
USB Devices Enabled:
1 Mouse
USB Functions [Enabled]
NEC USB 3.0 Controller [Enabled]
USB 2.0 Controller [Enabled]
USB 2.0 Controller Mode [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Legacy USB Support [Auto]
P6X58D-E BIOS Setup
Advanced
Options
Disabled
Enabled
Onboard 1394 Controller [Enabled]
[Enabled] Enables the onboard IEEE 1394a controller.
[Disabled] Disables the controller.
Marvell 9128 Controller [IDE Mode]
Allows you to select the Marvell 9128 controller operating mode.
[Disabled]
Disables the controller.
[IDE Mode] Set to [IDE Mode] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[AHCI Mode] Set to [AHCI Mode] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the onboard
storage driver to enable advanced Serial ATA features that increases
storage performance on random workloads by allowing the drive to
internally optimize the order of commands..