Asus P4VP-MX - Manual (Page 20)

1-10 Chapter 1: Product introduction
1.8 Central Processing Unit (CPU)
1.8.1 Overview
The motherboard comes with a surface mount 478-pin Zero Insertion Force (ZIF)
socket. The socket is designed for the Intel
® Pentium ® 4 and Prescott processors in
the 478-pin package. This processor supports 533/400MHz front side bus (FSB),
and allows data transfer rates of up to 4.3GB/s.
Note in the illustration that the CPU has a
gold triangular mark on one corner. This
mark indicates the processor Pin 1 that
should match a specific corner of the
CPU socket.
Incorrect installation of the CPU into the socket may bend the pins and
severely damage the CPU!
Gold Mark
Notes on Intel ® Hyper-Threading Technology
To use the Hyper-Threading Technology on this motherboard:
1. Buy an Intel ® Pentium 4 CPU that supports Hyper-Threading Technology.
Install the CPU.
2. Power up the system and enter BIOS Setup (see Chapter 2). Under the
Advanced Menu, make sure that the item Hyper-Threading Technology is set
to Enabled. The item appears only if you installed a CPU that supports
Hyper-Threading Technology.
3. Reboot the computer.
1. This motherboard supports Intel ® Pentium 4 CPUs with Hyper-Threading
Technology.
2. Make sure to enable the Hyper-Threading Technology item in the BIOS
before installing a supported operating system. See page 2-12.
3. To verify the Hyper-Threading feature, go to the Windows OS System
Properties -> Hardware -> Device Manager -> Processors. The list
should display two existing processors.
4. Hyper-Threading Technology is supported under Windows ® XP and later
versions only.
5. It is recommended that you install Windows ® XP Service Pack 1.
6. For more information on Hyper-Threading Technology, visit
www.intel.com/info/hyperthreading.