Asus K8N-LR - Manual (Page 69)

ASUS K8N-LR 4-15
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Disabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press
if you wish to configure the item.
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
SECODARY: enables
only the Secondary
IDE Controller.
BOTH: enables both
IDE Controllers.
IDE Configuration
OnBoard PCI IDE Controller [Both]
SATA0 IDE Interface [Enabled]
SATA1 IDE Interface [Enabled]
Hard Disk Write Protect [Disabled]
IDE Dectect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
First Boot Device from [P-ATA]
Configuration nVidia RAID ROM
OnBoard PCI IDE Controller [Both]
Enables or disables any or both the primary and/or secondary IDE
controllers. Configuration options: [Disabled] [Primary] [Secondary] [Both]
SATA0 IDE Interface [Enabled]
Enables or disables the SATA0 IDE Interface.
Configuration options: [Disabled] [Enabled]
SATA1 IDE Interface [Enabled]
Enables or disables the SATA1 IDE Interface.
Configuration options: [Disabled] [Enabled]
Hard Disk Write Protect [Disabled]
Enables or disables the hard disk wirte protection. This will be effective
only if device is accessed through BIOS.
Configuration options: [Disabled] [Enabled]