Asus SP98AGP-X - Manual (Page 13)

ASUS SP98AGP-X User’s Manual 13
III. INSTALLATION
Jumpers
1) RTCLR p. 15 Real Time Clock RAM (Operation/Clear Data)
2) KBV_SEL p. 18 Keyboard Voltage Selection
3) FS0, FS1, FS2 p. 16 CPU External Clock (BUS) Frequency Selection
4) BF0, BF1, BF2 p. 16 CPU:BUS Frequency Ratio
5) VID0, 1, 2, 3 p. 18 CPU Voltage Regulator Output Selection
Expansion Slots
1) System Memory p. 19 System Memory Upgrade
2) CPU ZIF Socket 7 p. 22 Central Processing Unit (CPU) Socket
3) SLOT 1, 2, 3 p. 23 16-bit ISA Bus Expansion Slots *
4) PCI 1, 2, 3 p. 23 32-bit PCI Bus Expansion Slots
Connectors
1) PS2KEYBOARD p. 25 PS/2 Keyboard Connector (6-pin Female)
2) PS2MOUSE p. 25 PS/2 Mouse Connector (6-pin Female)
3) PRINT p. 26 Parallel (Printer) Port Connector (25-pin Female)
4) COM1, COM2 p. 26 Serial Port COM1 & COM2 (Two 9-pin Male)
5) FLOPPY p. 26 Floppy Drive Connector (34-pin Block)
6) AUDIO (optional) p. 27 Audio Port -Line Out, Line In, Mic (Three 1/8” Female)
7) GAME (optional) p. 27 Joystick/Midi Connector (15-pin Female)
8) USB p. 27 Universal Serial BUS Ports 1 & 2 (Two 4-pin Female)
9) Primary/Second. IDE p. 28 Primary / Secondary IDE Connector (40-pin Blocks)
10) IDELED p. 28 IDE LED Activity Light
11) CHA_/CPU_/PWR_FAN p. 29 Chassis, CPU, Power Supply Fan Power Lead (3-pin Block)
12) MDM (optional)
p. 29 Modem connector (4 pins)
13) IR p. 30 Infrared Port Module Connector
14) ATXPWR p. 30 ATX Motherboard Power Connector (20-pin Block)
15) WOL p. 31 Wake on LAN (3 pins)
16) CD1 (optional) p. 31 Stereo audio in connector (4-pin Block)
17) CD2 (optional) p. 31 Stereo audio in connector (4-pin Block)
18) MSG.LED (PANEL) p. 32 System Message LED (2 pins)
19) SMI (PANEL)
p. 32 SMI Switch Lead (2 pins)
20) PWR (PANEL) p. 32 ATX Power & Soft-Off Switch Lead (2 pins)
21) RESET (PANEL) p. 32 Reset Switch Lead (2 pins)
22) KEYLOCK (PANEL) p. 32 System Power LED Lead (3 pins)
23) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins)
24) SPEAKER (PANEL) p. 32 Speaker Output Connector (4 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address, otherwise conflicts will occur.
III. INST
ALLA
TION