Asus P8H61/USB3 R2.0 - Manual (Page 35)

1-25 Chapter 1: Product introduction
6. Intel ® H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~4)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via
Serial ATA 3.0 Gb/s signal cables.
• You must install Windows ® XP Service Pack 3 or later version before using Serial ATA
hard disk drives.
• When using hot-plug and NCQ, set the SATA Mode item in the BIOS to [AHCI Mode].
See section 2.5.4 SATA Configuration for details.
P8H61 Series
SATA3G_2
GND
RSATA_TXP
2
RSATA_TXN
2
GND
RSATA_RXP2 RSATA_RXN2
GND
SATA3G_4
GND
RSATA_TXP4 RSATA_TXN
4
GND
RSATA_RXP4 RSATA_RXN
4
GND
SATA3G_1
GND
RSATA_TXP
1
RSATA_TXN
1
GND
RSATA_RXP1 RSATA_RXN1
GND
SATA3G_3
GND
RSATA_TXP3 RSATA_TXN
3
GND
RSATA_RXP3 RSATA_RXN
3
GND
P8H61 Series SATA connectors
7. USB connectors (10-1 pin USB56, USB78, USB910)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
The USB module cable is purchased separately.
P8H61 Series USB+5V USB_P10- USB_P10+ GND NC
USB+5V USB_P9- USB_P9+
GND
USB910
PIN 1
USB+5V USB_P8- USB_P8+ GND NC
USB+5V USB_P7- USB_P7+
GND
USB78
PIN 1
USB+5V USB_P6- USB_P6+ GND NC
USB+5V USB_P5- USB_P5+
GND
USB56
PIN 1
P8H61 Series USB2.0 connectors