Asus A8V Deluxe - Manual (Page 83)

ASUS A8V Deluxe motherboard 4-17
Memclock Mode [ Auto]
Allows you to set the memory clock mode. Set by the code using [Auto]
or select [Manual] to set using one of the standard values.
Configuration options: [Auto] [Limit]
DRAM Over 4G Remapping [Disabled]
Enable this item when 4 gigabytes or more DRAM is installed to remap
the memory block just below 4G and move it above 4G.
Configuration options: [Disabled] [Enabled]
Bank Interleaving [Disabled]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Enabled] [Disabled]
Node Interleaving [Disabled]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Configuration options: [Auto] [Disabled]
Burst Length [8 Beats]
Sets the burst length in beats. Set to 4 Beats when using 64-bit Dq.
Configuration options: [8 Beats] [4 Beats]
CAS Latency (CL) [Auto]
Sets the CAS Latency. Configuration options: [Auto] [2.0] [3.0] [2.5]
TRC [Auto]
Sets the TRC.
Configuration options: [Auto] [7 CLK] [8 CLK] [9 CLK] [10 CLK]
[11 CLK] [12 CLK] [13 CLK]
Memory Configuration
Memclock Mode [Auto]
DRAM Over 4G Remapping [Disabled]
Bank Interleaving [Disabled]
Node Interleaving [Disabled]
Burst Length [8 Beats]
CAS Latency (CL) [Auto]
TRC [Auto]
TRFC [Auto]
TRCD [Auto]
TWR [Auto]
TRWT [Auto]
TRAS [Auto]
TRP [Auto]
TWCL [Auto]
AsyncLat [Auto]
Read Preamble Setting [Auto]
2T Command [Auto]
MEMCLK can be set
by the code using
AUTO, or if you use
LIMIT, you can set
one of the standard
values.