Asus A7V333 - Manual (Page 82)

66 Chapter 4: BIOS Setup
SDRAM Active to Precharge Delay [6T]
This item controls the number os SDRAM clocks used for SDRAM
parameters.
SDRAM 1T Command Control [Disabled]
This item controls the pulse signal for DDR commands. The [Disabled]
default is equivalent to 2T and enabled, to 1T. Configuration options:
[Disabled] [Enabled] [Auto]
SDRAM Bank Interleave [Auto]
Configuration options: [None] [2 banks] [4 banks] [Auto]
Graphics Aperture Size [64MB]
This feature allows you to select the size of mapped memory for AGP
graphic data. Configuration options: [4MB] [8MB] [16MB] [32MB] [64MB]
[128MB] [256MB]
AGP Capability [4X Mode]
This motherboard supports the AGP 4X interface that transfers video data
at 1066MB/s. AGP 4X is backward-compatible, so you may keep the
default [4X Mode] even if you are using an AGP 1X video card. When set
to [1X Mode], the AGP interface only provides a peak data throughput of
266MB/s even if you are using an AGP 4x card.
Configuration options: [1X Mode] [4X Mode]
AGP Drive Strength [Auto]
Configuration options: [Auto] [Manual]
AGP Drive N Control [E]
Useful test parameters. Configuration options: [Auto] [Manual]
AGP Drive P Control [F]
Useful test parameters. Configuration options: [Auto] [Manual]
Video Memory Cache Mode [UC]
USWC (uncacheable, speculative write combining) is a new cache technology
for the video memory of the processor. It can greatly improve the display
speed by caching the display data. You must set this to UC (uncacheable) if
your display card does not support this feature, otherwise the system may
not boot. Configuration options: [UC] [USWC]
Memory Hole At 15M-16M [Disabled]
This field allows you to reserve an address space for ISA expansion cards.
Setting the address space to a particular setting makes that memory space
unavailable to other system components. Expansion cards can only access
memory up to 16MB. Configuration options: [Disabled] [Enabled]
PCI 2.1 Latency Compliant [Disabled]
Select enable for undetected PCI cards or for nonPCI 2.2 compliancy.
Configuration options: [Enabled] [Disabled]