Asus A7V333 User Manual

Page 44

Text mode
Original mode

Chapter 2: Hardware information

7) IDE Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE
connectors cause the IDE LED to light up.

8) Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After
connecting the single end to the board, connect the two plugs on the other
end to the floppy drives. (Pin 5 is removed to prevent inserting in the
wrong orientation when using ribbon cables with pin 5 plugged).

A7V333

NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.

A7V333 Floppy Disk Drive Connector

PIN 1

FLOPPY

A7V333

A7V333 IDE Activity LED

TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.

IDELED