Asus A7V333 - Manual (Page 105)

ASUS A7V333 motherboard user guide 87
5.4.1 Installing the Hard Disks
The RAID 0 setting allows users to reformat two hard disks with the same
new OS simultaneously. RAID 1 arrays can use a pre-existing hard disk
along with a blank hard disk, or two new hard disks.
FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.
Auto Setup . . . . . . . . . . [ 1 ]
View Drive Assignments . . . . [ 2 ] [ 2 ]
View Array . . . . . . . . . . [ 3 ] [ 3 ]
Delete Array . . . . . . . . . [ 4 ] [ 4 ]
Rebuild Array. . . . . . . . . [ 5 ] [ 5 ]
Controller Configuration . . . [ 6 ] [ 6 ]
Press 1..6 to select Option [ESC] Exit
[ Main Menu ]
[ Keys Available ]
1. Boot-up your computer once more. If this is the first time you have booted
with two hard disks correctly installed, then MBFastTrak133™ “Lite” BIOS
scans the IDE drives and displays this screen:
2 . Press keys to display the FastBuild™ Utility Main Menu:
1. Install the first and second hard disk into the hard disk bays of your system.
Connect each hard disk drive with a separate UltraDMA/100 cable, one
to the Promise IDE1 connector, and the other to the Promise IDE2
connector onboard the A7V333. NOTE: Do not connect any other types
of IDE devices to the Promise IDE connectors; they support hard disk
drive devices only.
2. Connect the power cables to the hard disks.
3. Make sure the RAID_EN jumper is reset to [1-2] and, if available, ensure
the BIOS settings in the Advanced PCI Configuration sub-menu are set
to enable RAID arrays: “SCSI/ATA100 Boot Sequence” field should be
set to [ATA100/SCSI] and the “Load Onboard ATA BIOS” field should be
set to [Auto].
4. Boot-up the PC.
5.4.2 Enter FastTrak100 BIOS and FastBuild Utility