Asus P5N73-CM - Manual (Page 48)

1-36 Chapter 1: Product introduction
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
9. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC’97 audio standard.
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
• By default, this connector is set to AC97 Audio. If you want to connect a
High Definition front panel audio module to this connector, set the Front
Panel Support Type item in the BIOS to [HD Audio]. See section “2.4.5
Onboard Device Configuration” for details.
P5N73-CM Azalia Analog Front Panel Connector
R
HP_HD
MIC2_L
HP_R HP_L
MIC2_J
D
Jack_Sens
e
MIC2_R
PRESENSE# AGND
AAFP
Legacy AC’97-compliant
pin definition
NC
MIC2_L
Line out_R Line out_L
NC
NC
MIC2_R
NC AGND
Azalia-compliant
pin definition
P5N73-CM
CHASSIS
+5VSB_MB
Chassis Signal
GND (Default)
P5N73-CM Intrusion Connector
R
P5N73-CM