Asus P8B75-M LX/TW - Manual (Page 62)

Chapter 2: BIOS information 2-18
2.5.4 System Agent Configuration
Memory Remap Feature [Enabled]
[Enabled] Allow you to enable remapping the memory above 4GB.
[Disabled] Disables this function.
Graphics Configuration
Primary Display [Auto]
Allows you to decide which graphics controller to use as the primary boot device. Configuration
options: [Auto] [iGPU] [PCIE] [PCI]
iGPU Memory [64M]
Allows you to select the amount of system memory allocated to DVMT 5.0 used by the iGPU.
Configuration options: [32M] [64M] [96M] [128M] ~ [416M] [448M] [480M] [512M] [1024M]
Render Standby [Enabled]
Allows you to enable the Intel Graphics Render Standby support to reduce the iGPU power use
when idle. Configuration options: [Disabled] [Enabled]
iGPU Multi-Monitor [Disabled]
Allows you to enable or disable the iGPU Multi-Monitor. For Lucid Virtu Universal MVP function
support, set this item to [Enabled] to empower both the integrated and discrete graphic cards. The
iGPU shared memory size will be fixed at 64MB. Configuration options: [Disabled] [Enabled]
NB PCIe Configuration
Allows you to configure the NB PCI Express settings.
PCIEX16_1 Link Speed [Auto]
Allows you to configure the PCIE x16_1 speed. Configuration options: [Auto] [Gen1] [Gen2]
2.5.5 AMT Configuration
The items in this menu allow you to change the Intel ® Active Management Technology (AMT)
feature.
Intel AMT [Enabled]
Allow you to enable or disable the Intel ® Active Management Technology (AMT) in the BIOS
extension. Configuration options: [Enabled] [Disabled]
• iAMT H/W is always enabled. This option just controls the BIOS extension execution. If
enabled, this requires additional firmware in the SPI device.
• The following two items become configurable only when you set the Intel AMT item to
[Enabled].
Invoke MEBx [Disabled]
This item become configurable only when the previous item is set to [Enabled] and allows
you to enable or disable this function. Configuration options: [Enabled] [Disabled]
Un-Configure ME [Disabled]
Sets this item to [Disabled] to unconfigure AMT/ME without using a password or set it to
[Enabled] to use a password. Configuration options: [Enabled] [Disabled]