Asus P5Q Premium - Manual (Page 158)

4-40 Chapter 4: Software support
SteelVine Manager main screen
Using SteelVine Manager
To use SteelVine Manager to create a disk array set
1. In the SteelVine Manager main screen, select the drives connected to
the SATA_E12 or SATA_E34 ports, and click Configure box. The Basic
Configuration Wizard appears.
2. Choose a drive mode to configure
from Storage Policy, and click
Apply. The system takes about
10 seconds for the change to take
effect.
3. Restart the computer.
• It is recommended using two new hard disks for this setup.
• All original data of the hard disks connected to the SATA_E2 (white, port 1)
and SATA_E4 (white, port 3) connectors on the motherboard will be erased
for the EZ Backup setup. Make necessary backup before the setup.
• All original data of the two / four hard disks will be erased for the Super
Speed setup. Make necessary backup before the setup.
Drive
Information
Capacity
Information
Configure
box
Volume
Information
Show drives connected
to the SATA_E12 ports
Drive
Status
Show drives connected
to the SATA_E34 ports
Current setting