Asus M3N78-EH - Manual (Page 39)

ASUS M3N78-EH 1-27
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5,
SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA
3Gb/s hard disk and optical disk drives. The Serial ATA 3Gb/s is backward
compatible with Serial ATA 1.5Gb/s specification. The data transfer rate of the
Serial ATA 3Gb/s is faster than the standard parallel ATA with 133 MB/s (Ultra
DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 10, RAID 5, and JBOD configuration through the onboard
NVIDIA nForce 730a chipset.
M3N78-EH SATA Connectors
R
M3N78-EH
G
ND
RS
AT
A_
TX
P6
RS
AT
A_
TX
N6
G
ND
RS
AT
A_
RX
P6
RS
AT
A_
RX
N6
G
ND
SATA6
G
ND
RS
AT
A_
TX
P5
RS
AT
A_
TX
N5
G
ND
RS
AT
A_
RX
P5
RS
AT
A_
RX
N5
G
ND
SATA5
G
ND
RS
AT
A_
TX
P4
RS
AT
A_
TX
N4
G
ND
RS
AT
A_
RX
P4
RS
AT
A_
RX
N4
G
ND
SATA4
G
ND
RS
AT
A_
TX
P2
RS
AT
A_
TX
N2
G
ND
RS
AT
A_
RX
P2
RS
AT
A_
RX
N2
G
ND
SATA2
G
ND
RS
AT
A_
TX
P3
RS
AT
A_
TX
N3
G
ND
RS
AT
A_
RX
P3
RS
AT
A_
RX
N3
G
ND
SATA3
G
ND
RS
AT
A_
TX
P1
RS
AT
A_
TX
N1
G
ND
RS
AT
A_
RX
P1
RS
AT
A_
RX
N1
G
ND
SATA1
Important note on Serial ATA
Install the Windows ® XP Service Pack 1 before using Serial ATA.
• For detailed instructions on how to configure RAID 0, RAID 1, and
RAID 10, RAID 5, and JBOD, refer to the RAID manual in the support CD.
• If you intend to create a Serial ATA RAID set using these connectors, set
the SATA Mode select item in the BIOS to [RAID Mode]. See
page 2-20 for details.
• If you change the SATA Mode select item in the BIOS to [RAID Mode] or
[AHCI Mode], set the Onboard PCI IDE Controller to [Disabled] to make
sure SATA5 and SATA6 (the black ports) work normally.
• If you want to do the task as GHOST, we suggest you connect the original
disk to the SATA5 or SATA6.