Asus P8P67 LE - Manual (Page 43)

1-31 Chapter 1: Product introduction
7. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
The S/PDIF module is purchased separately.
Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside the
system may damage the motherboard components. These are not jumpers! Do not place
jumper caps on the fan connectors!
6. CPU, chassis, and power fan connectors
(4-pin CPU_FAN, 4-pin CHA_FAN1, 4-pin CHA_FAN2, 3-pin PWR_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that the
black wire of each cable matches the ground pin of the connector.
• The CPU_FAN connector supports a CPU fan of maximum 2A (24 W) fan power.
• Only the CPU_FAN, CHA_FAN1 and CHA_FAN2 connectors support the ASUS Fan
Xpert feature.
• If you install two VGA cards, we recommend that you plug the rear chassis fan cable
to the motherboard connector labeled CHA_FAN1 or CAH_FAN 2 for better thermal
environment.
P8P67 LE
P8P67 LE fan connectors
CPU_FAN
CHA_FAN1 CHA_FAN2
CPU
FA
N PWM
CPU
FA
N IN
CPU
FA
N PW
R
GND
GND CPU
FA
N PWR
CPU
FA
N IN
CPU
FA
N PWM
GND
CPU FAN PWR
CPU FAN IN
CPU FAN PWM
Rotation
+12V GND
PWR_FAN
SPDIF_OUT
+5
V
SPDIFOU
T
GND
P8P67 LE
P8P67 LE Digital audio connector