Asus WL-169gE - Manual (Page 11)

ASUS WLAN Card 11
Chapter 2 - Installation
Chapter 2 Installation
Configuring with the WLAN utility (Ad Hoc)
The WLAN card supports Ad Hoc mode which allows communication between
wireless stations without an AP.
2. Click the Config button to set the WLAN
Card to Ad Hoc connection mode, Set the
SSID to that of the target Ad Hoc node,
then select a Channel on which the Ad Hoc
nodes are to communicate.
3. Click the Survey button to scan for the Ad
Hoc nodes. Select the node you want to
communicate with and press Connect.
4. If the encryption settings of your WLAN
Card are different from those of the other
Ad Hoc nodes, you are prompted to make
the encryption of the two nodes identical.
Click Apply to activate the settings.
1. Right-click the wireless connection icon
and select Wireless Settings.
5. Check the Status page to see the association
state. If connection is established, the box
shows “Connected - xx:xx:xx:xx:xx:xx”.
6. Check the Connection tab to see the
signal strength. Click OK to exit the utility.