Asus M3A-H/HDMI - Manual (Page 69)

ASUS M3A-H/HDMI 2-21
Memory Hole Remapping [Enabled]
Allows you to enable or disable memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]
DCT Unganged Mode [Disabled]
Allows selection of the unganged DRAM mode.
Configuration options: [Disabled] [Enabled]
Power Down Enable [Enabled]
Allows you to enable or disable DDR power down mode.
Configuration options: [Disabled] [Enabled]
Power Down Mode [Channel]
Appears only when you enable the Power Down Enable item.
Configuration options: [Channel] [Chip Select]
Read Delay [Auto]
Sets the memory read delay mode.
Configuration options: [Auto] [0.5 Memory CLKs] [1.0 Memory CLKs] [1.5 Memory
CLKs] [2.0 Memory CLKs] [2.5 Memory CLKs] [3.0 Memory CLKs] [3.5 Memory
CLKs] [4.0 Memory CLKs]
DCQ Bypass Maximu [Auto]
Sets the DCQ Bypass Maximu.
Configuration options: [Auto] [0x] [1x] [2x] [3x] [4x] [5x] [6x] [7x] [8x] [9x] [10x] [11x]
[12x] [13x] [14x] [15x]
DRAM Timing Configuration
This sub-menu allows selection of the DRAM Timing Configuration.
BIOS SETUP UTILITY
Advanced
DRAM Timing Configuration
Memory Clock Mode [Auto]
2T Mode [Auto]
DRAM Timing Mode [Auto]
Options
Auto
Limit
Manual
The configuration options for some of the following items vary depending on the depending on the
DIMMs you install on the motherboard.
Memory Clock Mode [Auto]
Allows selection of the DRAM Frequency programming method.
Configuration options: [Auto] [Limit] [Manual]