Asus P5B-VM SE - Manual (Page 64)

2-16 Chapter 2: BIOS setup
PIO Mode [Auto]
Selects the PIO mode.
Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology. Configuration
options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
2.3.5 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
IDE Configuration
SATA#1 Configuration [Enabled]
SATA#2 Configuration [Enabled]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
JMB368 Controller [Enabled]
SATA#1 Configuration [Enabled]
Allows you to enable or disable the SATA#1 Configuration. Configuration options:
[Disabled] [Enabled]
SATA#2 Configuration [Enabled]
Allows you to enable or disable the SATA#2 Configuration. Configuration options:
[Disabled] [Enabled]
Hard Disk Write Protect [Disabled]
Allows you to enable or disable the hard disk write protection. This will be effective
only if device is accessed through BIOS. Configuration options: [Disabled]
[Enabled]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]