Asus E35M1-I User Manual
Page 22
ASUS E35M1-I
1-12
4.
Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~6)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
• These connectors are set to [IDE Mode] by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors.
• When using hot-plug and NCQ, set the OnChip SATA Type item in the BIOS to [AHCI
Mode]. See section 2.5.2 SATA Configuration for details.
5.
USB 2.0 connectors (10-1 pin USB78, USB910, USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
The USB module cable is purchased separately.
E35M1-I
GN
D
RSATA_TXP4
RSATA_TXN4
GN
D
RSATA_RXP4
RSATA_RXN4
GN
D
SATA6G_4
SATA6G_2
GN
D
RSATA_TXP2
RSATA_TXN2
GN
D
RSATA_RXP2
RSATA_RXN2
GN
D
GN
D
RSATA_RXN3
RSATA_RXP3
GN
D
RSATA_TXN3
RSATA_TXP3
GN
D
GN
D
RSATA_RXN1
RSATA_RXP1
GN
D
RSATA_TXN1
RSATA_TXP1
GN
D
SATA6G_3
SATA6G_1
GN
D
RSATA_TXP6
RSATA_TXN6
GN
D
RSATA_RXP6
RSATA_RXN6
GN
D
SATA6G_6
GN
D
RSATA_RXN5
RSATA_RXP5
GN
D
RSATA_TXN5
RSATA_TXP5
GN
D
SATA6G_5
E35M1-I SATA 6.0Gb/s connectors
E35M1-I
E35M1-I USB2.0 connectors
PIN 1
NC
GN
D
USB_P9+
USB_P9-
USB+5V
GN
D
USB_P10
+
USB_P10
-
USB+5V
USB910
PIN 1
NC
GN
D
USB_P7+
USB_P7-
USB+5V
GN
D
USB_P8+
USB_P8-
USB+5V
USB78
PIN 1
NC
GN
D
USB_P11+
USB_P11-
USB+5V
GN
D
USB_P12
+
USB_P12
-
USB+5V
USB1112