Asus M2N-VM SE HDMI User Manual

Page 36

1-24

Chapter 1: Product introduction

2. USB device wake-up (3-pin PS2_USBPW1-4, USBPW5-8, USBPW9-12)

Set these jumpers to +5V to wake up the computer from S1 sleep mode

(CPU stopped, DRAM refreshed, system running in low power mode) using

the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep

modes.
The USBPW1-4 jumpers are for the rear USB ports. The USBPW5-8 and

USBPW910 jumpers are for the internal USB connectors that you can

connect to additional USB ports.

• The USB device wake-up feature requires a power supply that can

provide 500mA on the +5VSB lead for each USB port. Otherwise,

the system will not power up.

• The total current consumed must NOT exceed the power supply

capability (+5VSB) whether under normal condition or in sleep mode.

M2N-VM SE HDMI

3. HDJ1 Setting

This jumper allows you to switch between the HDMI and the DVI features.

Set this jumper to pins 1-2 (HDMI) to enable the HDMI feature. Set this

jumper to pins 2-3 to enable the DVI feature.

M2N-VM SE HDMI

(Default)