Asus T4-M3N8200 - Manual (Page 66)

5-15 ASUS T-Series M3N8200
5.3.4 Primary and SATA IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press to display the IDE device information.
Onboard IDE Controller [Enabled]
Allows you to disable or enable the onboard IDE controller.
Configuration options: [Disabled] [Enabled]
OnChip S-ATA Controller [Enabled]
Allows you to disable or enable the onChip SATA controller.
Configuration options: [Disabled] [Enabled]
The following items appear only when the onChip SATA controller item is set
to [Enabled].
SATA Mode Select [SATA Mode]
Allows you to disable or set the onchip Serial ATA controller mode.
Configuration options: [SATA Mode] [RAID Mode] [AHCI Mode]
• If you install SATA 3Gbps harddisk with NCQ feature, we recommend that
you set this feature to [AHCI] for better performance.
• If you want to install 2 SATA harddisk for RAID system, please set this
feature to [Raid] before you install the OS.
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
Main
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
Primary IDE Master
Device : Not Detected
Type [Auto]
LBA/Large Mode [Auto]
Block(Multi-sector Transfer)M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]
Select the type of
device connected to
the system.