Theatre Solution Lecture Seating Aeron - Manual (Page 4)

Aeron Lecture Seating Specifications
Page 4 of 4
D. Provide manufacturers standard power/data module consisting of two electrical outlets and two Category 6
RJ-45 data jacks. Electrical and data jacks are to be black in color. The module shall be mounted in the
worksurface centered and shared between two seated occupants.
E. Provide necessary quantities of manufacturers standard wire management raceways for the concealment
and routing of data wiring. Data wiring is to be provided and installed by others and is not the responsibility
of the manufacturer or its’ installers.
3.6 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133
PART 4 – WARRANTY
4.1 The lecture seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:
A. Seat/Table Supports, Worksurfaces, and Modesty Panels – The manufacturer shall warrant it’s products
against failures and manufacturing defects for the life of the product. This warranty applies to the original
purchaser and is non-transferable. The manufacturer will provide parts and labor to replace defective parts
for the first two years after the installation. Thereafter, the manufacturer will provide replacement parts for
the life of the product.
B. Chair Uppers – The manufacturer shall warrant the product for five (5) years from the date of shipment.
This warranty applies to the original purchaser and is non-transferable. The manufacturer will provide parts
and labor to replace defective parts for the first two years after installation. Thereafter, TSI will provide
replacement parts for the remaining 3 years.
C. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than an authorized seating manufacturer technician will void
this warranty. This warranty does not apply to fabrics or products not installed by authorized seating
manufacturer technicians.
PART 5 - EXECUTION
5.1 EXAMINATION
A. Examine site conditions, with installer present, for compliance with requirements for construction tolerances
as they affect anchors and fasteners, and location of junction boxes.
B. Do not proceed until unsatisfactory conditions have been corrected.
5.2 GENERAL
A. Comply with seating manufacturer’s printed installation instructions applicable to products.
B. Locate seating in locations indicated on approved shop drawings, with required clearances.
C. Install standards in locations conforming to seating layout, with each standard attached to substrate by no
less than two anchoring devices of size and type required to insure that chairs are stable under conditions
of actual use.
D. Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved
rows are installed on proper radius and are oriented toward the center point of the radius. Verify that
moving components operate smoothly and quietly.
5.3 ADJUSTING
A. Adjust as required to assure that the seats in each row are aligned when in the closed position.
B. Touch-up minor abrasions and imperfections in painted finishes with coating that matches factory-applied
finish.
C. Replace any upholstery that has been damaged during installation.
END OF SPECIFICATION
® Herman Miller, Aeron, Equa 2, Pellicle, and Kinemat are among the registered trademarks of Herman Miller, Inc.